Intelligent Lighting UFO High Bay Light with Motion Sensor
IMicrowave motion sensor ,the sensor are built in adjustable daylight sensors. Dimmable and Motion sensor 2 in one light, saving energy better than normal led light
Performance
P/N |
XP-HB100N00 |
XP-HB150N00 |
XP-HB200N00 |
Input Power |
100W |
150W |
200W |
Lumen Output |
15000LM |
22500LM |
30000LM |
Light Efficiency |
140~150lm/w |
||
Color Temperature |
3000K/4000K/5000K/5700K/6500K |
||
LED Source |
LUMILEDS 3030 SMD / CREE 3030 SMD / SANAN 2835 SMD |
Power Factor |
>0.95 |
Input Voltage |
AC100-277V / AC200-240V / AC200-480V, 50/60HZ |
THD |
<20% |
Physical:
Net/Gross Weight |
2.1kgs/2.7kgs |
3.1kgs/3.9kgs |
4.5kgs/5.5kgs |
Lamp Dimention |
280*170mm |
320*180mm |
380*186mm |
Packing(1pc/ctn) |
325*325*175mm |
375*375*185mm |
425*425*185mm |
Housing |
Die casting Aluminum + PC lens |
||
Beam Angle |
60°, 90°, 120° |
||
Installation |
Ceiling, suspend, pipe mounted(optional) |
||
Operation |
-35°C~55°C |
||
Humidity |
20%~85%, non-condensing |
||
Finish |
black/white |
||
Waterproof Rating |
IP65 |
Using 0-10V dimming driver. And built in daylight sensor, very easy to install and cost-effective
With sufficient ambient light, the sensor does not switch on the lamp
With insufficient amibient light,the sensor swicthes on the lamp when motion is detected
After hold time, the sensor dims the lamp at a low light level if no new motion triggar
After stand by period, the sensor switches off the lamp if no motion is detected in its detection zone
Setting:
Detection area
detection area can be reduced by selecting the combination on the DIP switches to fit precisely each application
Hold time
Refers to the time period the lamp remains at 100% illumination after no motion detected
Stand-by period
Refers to the time period the lamp remains at a low light level before it completely switches off at a long absence of people.
When set to disable mode,the low light is maintained until motion is detected
Stand-by dimming level
The low light level you would like to have after the hold time in the long absence of people
Daylight sensor
The sensor can be set to only the lamp to illuminated below a defined ambinent brightness threshold
When set to Disable mode,the daylight sensor will switch on the lamp when motion is detected regardless of ambient light level
Note that daylight sensor is active only when lamp totally switches off